1止血带密闭回收后，首先进行评估止血带质量情况，检查污染程度。如污染严重,在流动水下进行反复冲洗。放入多酶清洗溶液中浸泡5分钟。

1 tourniquet closed recovery, first of all to assess the quality of tourniquet, check the degree of pollution. Such as serious pollution, repeated flushing under flowing water. Soak in a multienzyme solution for 5 minutes.

2质量要求：按厂家多酶液的说明注意酶液的温度、时间，清洗液液面浸过止血带1-2cm。1液面下揉搓或用纱布擦洗止血带外面的污垢。

2 quality requirements: according to the manufacturer's multi enzyme liquid note, pay attention to the temperature and time of the enzyme fluid, cleaning liquid level, soaked tourniquet 1-2cm. 1 rub under the surface or use gauze to scrub the dirt outside the tourniquet.

3流动水下揉搓或用纱布擦洗止血带外面的污垢。

3 remove the dirt outside the tourniquet by rubbing it under water or using gauze.

4用高压水枪（自来水）冲洗止血带管腔内污垢。

4 use the high pressure water gun (tap water) to wash the dirt inside the tourniquet.

5质量要求：外观目测无污渍、光洁、透亮。

5 quality requirements: visual appearance, no stains, bright and clean.

6用温热水反复冲洗、再用纯化水进行漂洗。

6 rinse repeatedly with warm water and rinse with purified water.

7用高压水枪（纯化水或蒸馏水）进行冲洗止血带管腔内污垢。纯化水化或蒸馏水进行漂洗、终末漂洗，

7 use a high pressure water gun (purified water or distilled water) to flush the dirt inside the tourniquet. Purified, distilled or distilled water for rinsing and rinsing at the end,

8质量要求：止血带无清洗液残留，无污渍。5.1放入含有效氯1000mg/L消毒液中浸泡30分钟或煮沸槽中煮沸消毒。温度90℃，时间≥5分钟。

8 quality requirements: tourniquet, no cleaning liquid residue, no stains. 5.1 put into the disinfectant containing the effective chlorine 1000mg/L for 30 minutes or boil in a boiling bath to sterilize. The temperature of 90 DEG C, longer than 5 minutes.

9质量要求：消毒容器应加盖、止血带应全部淹没在消毒液中，消毒液液面浸过湿化瓶1-2cm，，并控制有效氯浓度及时间。

9 quality requirements: disinfection containers should be stamped, tourniquet should be completely submerged in the disinfectant, the disinfectant liquid level soaked wet bottle 1-2cm, and control the effective chlorine concentration and time.